Methamphetamine Synthesis of methamphetamine using red phosphorus and iodine

[HewHiSt]

Proportions :

2g Ephedrine or pseudoephedrine
0.6g Red phosphorus
4g Iodine
5ml Distilled water
8ml 25% Sodium hydroxide
3g Sodium trisulphate
20ml Solvent

Ingredients :

- Ephedrine or Pseudoephedrine
- Red phosphorus
- Iodine
- Aluminium foil
- Methanol
- Solvent (Coleman Fuel, ether, DCM, etc.)
- Hydrochloric acid
- Sodium hydroxide
- Sodium trisulphate
- Demineralised water
- Ice

Equipment :

- Grinder/mortar
- Beakers
- Erlenmeyer flasks
- Pyrex dishes
- Filters
- Scalpel (for scraping)
- Pipette

Procedure :

1. Extraction:

a) To extract ephedrine or pseudoephedrine, grind them, mix the powder with methanol then leave to stand, then filter, put the liquid in a dish and place it over a low heat so that the methanol evaporates

b) To extract red phosphorus, soak the scraper from the matchbox in a solvent (methanol, acetone, ..) then remove it by gently scraping, you can also collect phosphorus from the end of the matches

c) To extract the iodine, pour the dye into a beaker and add twice the volume of hydrogen peroxide and a little hydrochloric acid, after 50 minutes stirring, filter


2. Reaction:

Pour the water and red phosphorus into an Erlenmeyer flask, then gradually add the iodine. This reaction is exothermic and produces toxic gas, so use a pipe to redirect the smoke into the water, then add the ephedrine or pseudoephedrine (a mild heat source can be used)

After 1 hour 30 minutes, immerse the Erlenmeyer flask in a cold water bath for 10 minutes.


3. Filtration :

Filter the solution (the red phosphorus collected can be reused).


4. Basing :

Add ice to the solution, then sodium hydroxide in small portions to obtain a pH of 13 or 14 (change from an acid to a base), then sodium trisulphate.


5. Separation:

Add a solvent and wait for the liquids to separate properly, then separate them with a pipette.


6. Crystallisation (liquid -> powder)

Create a hydrogen chloride gas generator, in a resealable container put some pieces of aluminium then some hydrochloric acid, use a pipe to direct the gas into the solution

Afterwards, filter the solution, the powder obtained is methamphetamine.


7. Recrystallisation (powder -> crystal)

The meth is added to a container with acetone (100ml for 40g of meth + 9.5ml of water) and heated to 52-54°C, after which it is left to cool for approximately 3 hours at room temperature and then placed in the freezer for 2 hours

OR

In alcohol which is left to evaporate.

 

[Hasan]

How many lies are you talking here

 

[Hasan]

How many lies are you talking about? Your knowledge of chemistry is zero. He says 5 ml of pure water and it will boil for 1.30 minutes, right? Are you stupid? Who can lose 5 ml of water for 1.30 hours, idiot?

 

[HewHiSt]

I was inspired by the following thread, which shows how to synthetize meth following the Moscow route

Methamphetamine from ephedrine tablets

Extraction of pseudoephedrine from pharmaceutical (Sudafed) tablets. Pseudoephedrine was extracted from Sudafed tablets using ethanol, ethanol/methanol (90:10% vol/vol) and methylated spirits. The solvents were chosen with reference to the relevant clandestine literature. For each extraction...

bbgate.com

This thread was itself made from a video (see the thread) I only translated and reworded the sentences so that people who speak my language understand better, the only thing I changed was the ‘2ml’ to ‘5ml’

So please be respectful with me and stop calling people 'idiot', especially as you're new here, even if I'm not very good at chemistry, you can tell me with respect