Cocaine Freebase through baking soda or ammonia

bblanco

Don't buy from me
Resident
Joined
Feb 14, 2023
Messages
94
Reaction score
43
Points
28
a note which swim adaptedin words as swim would say or prefers to do.

In a large metal spoon, old iron (no SS). Bow the handle from the "spoon" part so it can stand by it self. Make it stable.
combine 1 gram of cocaine hcl and ½ gram of baking soda (as most people have more easy access to this instead of ammonia but below more. ). Carefully fill the spoon with water to the its just head under and wait untill all is desolved. everything left and needs to be helped disolving should be removed already.

Place the spoon with all three ingredients over medium high to high heat until all of the baking soda has finished bubbling out. Just Slow. Best is like a kind of pond which is frozen. Dont think you are ready and if seems all water gone just play with spoon and flame and be chill.. all will be fine.

Your cocaine freebase will appear in the bottom of the spoon in the somewhat murky colored water that remains. The freebase will be yellowish gold in color.

Hold the spoon and from the wrist try to let the spoon move so your are kind a steering. counter clockwise. Pour out the remaining water with any residue left floating on top. Fill the spoon with fresh cold water over top of the freebase. Now, with a sharp,
non-serrated knife, gather the freebase from the spoon in one full motion and let it fall onto a ceramic plate. Now your done with the spoon.

Now, tilt the plate and let any excess water fall off. Don’t worry, the freebase will not move at all when tilted. With a paper towel, carefully wipe up any
remaining water from around the clump of freebase.

Run the same, non-serrated knife back and forth over the freebase clump. It will quickly change from an oily yellowish gold clump
into a rock hard white form within a minute or so. Once this happens, stop using the knife.

Now, with a sharp razor blade, carefully scrape up the white freebase into a pile. With the bottom of a medium size metal spoon, carefully crush up the freebase into a fine powder.

Now this next part is what everyone leaves out, but it is THE most crucial to obtaining pure freebase cocaine.
If you omit this part, you WILL also be smoking freebase amphetamine and freebase ephedrine, most assuredly.

Take a small drinking glass and fill it up with about 2 inches of fresh cold water. Now, pour your dry freebase pile into the glass of water.
Stir up the freebase for a minute or so. This will remove all traces of amphetamine, methamphetamine, ephedrine and psuedo-ephedrine from your freebase
because they will all dissolve in the water, while the cocaine freebase will NOT dissolve.

Hardly anyone knows about this step and it is the most crucial. Otherwise, no matter what step you decide to use for making freebase
(albeit aluminum foil, ammonia, bi-carb, etc), you’ll be carrying all of those adulterants right on thru to the end. They will ruin your cocaine high, believe me!

Once you have stirred the freebase and water for a minute or so, carefully pour out the water and freebase into a coffee filter paper.
You can pour fresh water into the glass and swish it around to collect any freebase that got left behind when pouring it into the filter paper. Now, the only substance left behind in your filter paper is the most pure freebase cocaine you will EVER experience!

Once the water has all gone thru the filter paper, you can pour the pure cocaine freebase out onto a clean plate.
Let it dry for another 3-4 minutes or so and smoke away. But stay in control... you are the master. it serves you, not the other way around..

tip: roll a joint and sprinkle a crushed fine line freebase over the hasj (weed also) but hasj gives a perfect balance in the up and dowen. No para para behaviour.. no tension no stress and if lucky on the right time you fall a sleep and save half for another moment... ciao

Total prep time: 30 minutes"
 

Osmosis Vanderwaal

Moderator in US section
Resident
Joined
Jan 15, 2023
Messages
1,598
Solutions
4
Reaction score
1,106
Points
113
Deals
1
It's so srtrange to me, your post mirrors another Europeans account, but my freebase floats on top of the water, just like the video on this site. I drag it to the heel of the spoon with a penny or a knife. I usually weigh mine and do 1/3 bs cocaine hclg cocaine (100 mg bs to 300mg C HCL)o. Sodiim carbonate works fine too I count like >one-one thousand, two one thousand and stop at 3 and let it react. Cocaine base vaporizes at 208f which is right below boiling point of water, so if it boils, it's too hot. From tap water temp it takes about 7 seconds to get hot. If you believe chemists, the pyrolisis product , annhydroecgonine starts being produced at 300f and is maxing production at 400f. This chemical is how they can tell you smoked it vs. snorted ate boofed ect. It inhibitsyour muscarinic acetylcoline receptors too, which can cause chest tightness and pain, It is liquid at room temps and is the oil that doesn't want to burn in your pipe or stem A butane lighter flame is about 3500f, so, needless to say if you blaze it, your making a lot of annhydroecgonine. I blaze it and it makes my ears ring, which, a "bell ringer" is something most people shoot for, but it's apparently noy really good for you. An adjustable e-dab rig set to mid 300'sF Is the way of the future, I've heard. Plasma lighters also are much cooler than butane, around 800f, I usually direct flame it for 3 seconds and then back way off for 3 seconds. Is sal ammoniac hard to get in some countries? every grocery store has it here in 30% auqeus solution. The ph is 9-10 which many people is a little hot for some tastes since base cocaine runs a low 8. You can add it to your spoon, it will react at room temp eventually, but what you get is like a powder since the water didn't get hot enough to melt it. The traditional freebase method is dissolve the hcl in water, add non-polar solvent (hexane, diethyl ether ect.) and neutralize the whole thing to about 9 with amonnia and shake . As the hcl neutralizes, the C migrates to the non-poler which is seperated and evaporated, leaving a pretty pure product, depending on your NPS. You can crush it and rinse it with h2o if you feel it is harboring ammonia or NPS. I've made crack with tums antacid before. If someone else is really enthusiastic about the subject, I'd love to talk more about it. I have questions like...when C hcl is mixed with h2o, I know it misces 50% in 7ph , C1+, h30, and cl- Where does the electron that quenches cocaine 1+ come from? Can cocaine solidify in the anionic state (1+)?
 
Top